Krell S-300i User Manual download pdf (Page 18)

1 4 Krell S-300i

Krell recommends using balanced interconnect cables. Balanced

interconnect cables not only can minimize sonic loss but are also

immune to induced noise, especially with installations using long

cables. Balanced connections have 6 dB more gain than single-

ended connections. When level matching is critical, keep this gain

value in mind.

Follow these steps to connect the S - 3 0 0 i to your system.

1 . Make sure all power sources and components are off before

connecting inputs and outputs.

2 . Neatly organize the wiring between the S - 3 0 0 i and all system

components. Separate AC wires from audio cables to

prevent hum or other unwanted noises from being introduced

into the system.

3 . Connect the left and right loudspeaker cables to the integrated

a m p l i f i e r ’s left and right loudspeaker output terminals (14).

The S-300i uses standard binding posts for each amplifier

channel. These connectors accept bare wire, pins, bananna

jacks or spade lugs. Use the red terminal for the positive con-

nection and the black terminal for the negative connection.

4. Connect the left and right outputs of your source components to

the appropriate analog inputs (15, 16, 17) on the S-300i.

The S - 3 0 0 i is equipped with one balanced input (B-1), three sin-

gle-ended inputs (S-1, S-2, or S-3), and one iPod input. The B-

1, S-1, S-2, and S-3 inputs can be configured for T h e a t e r

Throughput. See Optional Configurations, on page 17 for

information on configuring an input for Theater Throughput.

5 . Use the preamp outputs (19) to connect to an additional power

a m p l i f i e r.

6 . Plug the AC cord into the IEC connector (22) on the back

panel of the S-300i. Plug the remaining end into the AC wall

receptacle. Press the Power Button on the rear panel, The red

stand-by LED (2) illuminates and the display shows the soft-

ware version.

Pin 1 Shield (ground)

Pin 2 Non-inverting (hot) (0°)

Pin 3 Inverting (cold) (180°)

Connecting the

S-300i

to Your System

USING BALANCED

C O N N E C T I O N S

C o n n e c t i o n

S t e p s

Pin assignments for the

XLR connectors

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Comments to this Manuals

No comments

Krell S-300i User Manual Page 18

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Krell S-300i